Straight answers for a South Coast roof
The questions below come up on nearly every call. Each answer is short, says what can be known from a phone call and says what needs the roof itself to be read before a scope can be written.
- Leaks, flashing and tear-offs
- Triple-deckers and low-slope decks
- Coastal wind and storm damage
Get a fast quote
Fastest: call (833) 751-2102. Or send this and we call you back.
Leaks and new stains
What should I do about a stain that just appeared?
Photograph it, note the date and the weather of the last two days, and check the attic directly above it if that can be done safely. Then call (833) 751-2102 with the location. The source is often somewhere else along the framing.
Why does the water show up a room away from the leak?
Water runs along rafters, under sheathing and down the framing until it finds a low point. The stain marks that low point, not the place where the water got in.
Can a leak wait until the next scheduled visit?
A slow drip that shows only in heavy rain can often wait. A stain that is growing, or that is wet to the touch, should be seen the same day, with a temporary measure in place if needed.
Does a leak visit include the attic?
It should. The attic beneath the problem is where the entry point is most often found, and the findings are photographed and written up before a scope is agreed.
Bay wind and storms
Do shingles on the bay side fail first?
The windward edges usually fail first, but a gale that turns can load a side that has been sheltered for years. Check all four sides after a big wind, not only the one facing the street.
Is one lifted shingle a serious matter?
It can be. A lifted tab often means the sealant has lost its hold or a nail has backed out, and the gap lets rain under the layer below. Have it reset and the neighboring tabs checked.
Does salt air wear metal faster near the water?
It does. Salt and spray work on fasteners, seams and finishes, and the wear shows as corrosion and loose panels before other damage appears. A metal roof near the bay is worth inspecting more often.
What should I describe when I call about wind damage?
Describe where the damage is, which way the wind was blowing as you recall it, any covering you found in the yard and any water inside. Those details help decide what the visit brings.
Ice and the eave
Are ice dams a sign of a bad roof?
Not necessarily. Dams form when heat from the attic melts snow that refreezes at the cold eave. Ventilation, insulation and gutters decide how often that happens, and the roof's condition decides how much water gets in.
Should I clear snow from the lower edge myself?
Working on a snowy roof from a ladder is a serious fall risk. Keep the gutters clear from the ground where that is safe, and call for removal if ice has formed a dam.
What is an ice barrier for?
It is a membrane under the covering at the eave that protects the deck from water that backs up under the shingles. It does not stop a dam forming, and it works best with sound attic ventilation.
Does every nor'easter bring ice?
No. Ice dams need snow, heat from the attic and a hard freeze at the eave together. A storm that mostly rains rarely produces them.
Older roofs and old coverings
Can a new covering go over an old one?
Sometimes, and it depends on the roof and on the town. The inspection shows the deck and the layers, and the building department answers the permit question for the address.
Does an old cedar or slate roof need different work?
Yes. Slate, cedar and wood shake each have their own repair methods and fasteners, so the crew should name the covering before the repair is planned.
What happens to the decking under an old roof?
It is judged once the covering is open. Soft boards are replaced under an allowance stated in the scope, and the deck is photographed before new material goes down.
Why is old flashing so often patched?
Older flashing was often set around a chimney or a wall with sealant rather than a proper lap. A sound repair ties new metal into the courses instead of adding another layer of sealant.
Paperwork, permits and registration
Who decides whether I need a permit?
The building department of the town where the house stands. Permits are issued town by town, so an answer from a neighboring town does not carry over to your address.
What is the HIC number?
It is the home improvement contractor registration number issued through the state's Office of Consumer Affairs and Business Regulation. Ask for it before signing and check it with the state.
Who handles insurance questions?
Your own policy and insurer decide coverage. The Massachusetts Division of Insurance is the state regulator to contact about insurance questions.
What does the written scope need to show?
The layers, the deck allowance, each counted detail, the staging, the cleanup, the permit line and the payment stages. A scope that leaves one of these out is incomplete.
Question not answered here?
Call and ask. A technician will give you a straight answer, even if the answer is that you do not need us.