Fastest: call (833) 751-2102. Or send this and we call you back.
Ice Dams and Snow
Ice Dam and Snow Removal: what it covers
Quick answer
An ice dam is a ridge of ice that forms at the eave and holds meltwater behind it, forcing the water under the covering. New Bedford Roofing clears ice and snow from roofs across New Bedford and the nearby towns when it can be done safely, and calls at (833) 751-2102 get a crew out as conditions allow.
Ice dams form in a particular sequence. Heat from the house warms the attic and the roof boards, snow on the roof melts from the top down, and the water runs to the cold eave, where it freezes into a ridge. The next melt has nowhere to go but back up under the shingles, and it finds the nail holes and the laps.
On the South Coast the freeze and thaw cycle is the problem. A warm day followed by a hard freeze is enough to build a dam, and a nor'easter that drops wet snow and then turns cold can set several at once. Old houses with poor insulation and little ventilation are the most prone, because the heat escapes into the attic and keeps the snow melting above the cold edge.
The fix has two parts. The ice and snow have to come off in a way that does not damage the roof or the crew, and the water that got in has to be traced and dried. Removal alone will not stop the next dam, so the crew also looks at the attic insulation and ventilation and records what it finds for the homeowner to act on.
Do not climb onto a snowy or icy roof to clear it yourself. Falling from a roof in winter is a serious injury, and falling ice from an eave can strike people below. Keep walkways clear of the drop zone beneath the eave, and let a crew handle any dam that is over the gutter or near a window.
A ridge of ice at the eave that is thicker than the gutter and grows each cold week
Icicles hanging from the eave in a row above a stained wall
A ceiling stain on an upstairs wall beside an exterior corner after a thaw
Peeling paint or swollen trim along the fascia below the eave
Bare patches of roof that melt while the eave stays frozen
Water dripping from a light fixture on an outside wall in winter
Snow piled against the house wall where it slides off a steep roof
Our process
How our ice dam and snow removal visit works
Assess the roof and the access before climbing
The crew checks the snow depth, the ice thickness and whether the surface can be walked safely. A roof with a heavy load of snow, or a sheet of ice over the gutter, is not climbed until it is safe. The access is planned so the ladder stands on firm ground, clear of the eave ice that could fall.
Clear the snow with care
Snow is removed from the eave and from the first few feet of the roof with a soft tool, leaving the covering intact. Crews avoid steel shovels and anything that scrapes the shingles, because scraping lifts the granules and the edges. Snow is moved away from the house wall so it does not pile against the siding.
Remove the ice dam safely
Where an ice dam has formed, it is cleared with a method that does not chip the shingles, such as a steam or a warm-water system used from a secured position, or a carefully managed mechanical clearing. The crew stops if the covering starts to lift, and records the method used in the scope.
Trace and dry the leak
Once the ice is off, the attic and the ceiling where the water appeared are checked. Wet insulation is pulled and the boards are dried. The crew looks for the place where the water entered, which is usually a gap in the first course, a nail hole or a flashing joint at the eave.
Advise on the cause and the ice barrier
The written report names the likely cause, which is usually the attic heat, the insulation or the ventilation, and it lists what could be done to reduce the next dam. The question of whether a specific roof must carry an ice barrier is put to the town building department, since this site does not assert a requirement.
After a thaw, a ceiling in the upstairs hall shows a brown ring, and the homeowner sees a ridge of ice along the front eave with water running behind it.
What we do
The crew clears the gutter from the ground and checks the attic, where insulation is found pushed against the eave vent. The insulation is pulled back from the vent, the wet section is dried and the eave is reviewed for a membrane at the edge.
What to expect
The findings record the ice ridge, the insulation position and the wet framing, and the homeowner receives a short plan for ventilation and gutter clearing before the next winter.
Why do ice dams form on some houses and not others?
A dam forms when heat from the house melts the snow on the upper roof and the meltwater refreezes at the cold eave, and the rate of that heat loss is set by the attic.
A well-insulated attic with good ventilation keeps the roof boards cold, so the snow above stays frozen. A poorly insulated attic lets heat through, and the snow melts from the bottom up. Older houses, many of which have had their attics altered over decades, are the most prone to this, and the report looks at the attic first for that reason.
Why is a dam so damaging to the roof and the walls?
Ice behind the eave holds water against the shingles, and the melt finds its way under the laps, into the nail holes and along the rafters, where it stays wet for weeks.
The water does not run off a dam, it pools and works upward, so the leak can appear several feet from the eave. Wet wood that stays damp through winter begins to rot, and the gutter and fascia can pull away under the weight of the ice. A leak that appears after a thaw often began weeks earlier, and the attic check finds the path.
What is the ice barrier question?
An ice barrier is a membrane laid under the eave shingles. Whether a particular roof must have one is a matter for the local building department, and this site does not assert a state requirement.
Some crews describe an ice barrier as a state code requirement, but the sources this site could check do not confirm that as a general rule. The building department in the town where the house stands can say what applies to a particular roof. A membrane at the eave is a sound detail regardless, and it is included in the scope where the roof is being replaced.
Is snow removal from the roof always needed?
Not always. Light snow on a steep, well-shed roof usually slides off without help, while heavy snow or a dam at the eave is a reason to act.
The decision depends on the depth of the snow, the pitch of the roof and the layout of the house. Snow that slides onto a walkway or a parked car can cause injury, and the crew advises where snow should be cleared and where it should be left alone. Removal is never done in a way that puts a person on an icy surface without a plan.
Options
Types and options for ice dam and snow removal
Snow removal from the eave
The crew clears snow from the lowest feet of the roof and from the area where the next melt will run. The work is done with a soft tool and from a safe position, and the snow is moved clear of the house and the walkways so that a fresh slide does not land on someone.
Ice dam clearing
A dam at the eave is cleared with a method that protects the covering. Mechanical clearing is risky on shingles, and heat applied carelessly can melt the covering or the gutter. The crew chooses the method for the roof in front of it and records the choice in the report.
Self-adhering membrane at the eave
A membrane laid under the shingles at the eave, and up the roof for a set distance, keeps water from getting into the nail holes if a dam forms. It is a building detail, not a removal, and the scope includes it when the roof is being repaired or replaced rather than as an add-on in winter.
Attic air sealing and insulation
Warm air leaking from the living space into the attic melts the snow from below and feeds the dam. Sealing the attic floor at its penetrations and topping up the insulation reduces that heat. The work is recommended in the report, and it is often the change that prevents the dam from forming again.
Snow load on a flat or low-slope section
Flat sections and porch roofs hold snow longer than steep ones, and the weight can stress a deck or a drain. The crew checks for sagging and for a drain buried under snow, and clears the drain so meltwater can leave the roof.
Bristol County
Why ice dam and snow removal is different in the South Coast
Old houses in New Bedford and the nearby towns often have attics that were insulated unevenly or not at all, and those attics feed the snow melt that builds a dam at the eave. The report looks at the attic floor and the eave vents before it recommends a clearing.
Close-set city lots mean that snow and meltwater from one roof often land on a neighbor's wall or walk. A crew working on these houses notes where the snow should go and avoids dumping it against a shared wall or a neighbor's entrance.
Inland towns on the South Coast see heavier snow than the shore in some winters, and a roof with a long, flat section can carry more weight than a crew expects. The check looks at the flat sections for sag and at the drains for blockage before it recommends a clearing.
Still stuck? We pick up 24/7.
If it's an emergency, call now. For non-urgent ice dam and snow removal, send the form and we'll call you back.
A nor'easter brings wind, rain and sometimes snow, and the freeze-thaw cycles that follow leave ice at the eaves.
Read the guide
FAQ
Ice Dam and Snow Removal FAQs
Why is there an icicle hanging over my gutter?
An icicle at the eave usually means meltwater is running off the roof and freezing as it reaches the cold edge. A row of them with a ridge of ice behind is the start of a dam, and the crew should look at it before the next melt.
Can you stop ice dams from forming again?
Clearing a dam only removes the current ice. Reducing the heat that causes the dam, through attic air sealing and insulation, is what stops it recurring, and the report lists those steps in order of effect.
Is it safe to use a heat cable?
A heat cable can melt a channel through an ice dam, but it is a band-aid that depends on the cable being installed and used correctly. The crew can advise whether one is sensible for the roof, and it does not recommend one as a substitute for fixing the attic.
Will snow removal damage the shingles?
It can, if the wrong tool or method is used. Metal shovels and scraping lift the granules and the edges, so crews use soft tools and work from a secure position, and they stop if the covering starts to move.
Do you clear snow from a flat roof too?
Yes, where the roof can be reached safely. A flat section holds snow and can carry a drain under the load, so the crew clears the drain first and checks the deck for sag before it decides how much snow to remove.
How do I arrange a visit during a storm?
Call (833) 751-2102. The crew works when conditions allow it to reach the roof safely, and the first call records the location of the ice or snow so the visit can be planned around the access.