Roof Repair
The failed section is found, traced and rebuilt, so the rest of the covering can stay on for years.
The work falls into a few groups: repairs at leaks and flashing, full replacements, low-slope and triple-decker decks, ice protection, and inspections after a storm. Each job is assigned to a crew that does that kind of work, and the scope names the items that apply.
Fastest: call (833) 751-2102. Or send this and we call you back.
Most calls are about a leak, but the leak is often the visible end of a problem that started at a joint, a valley or the edge of a low-slope deck. The first visit is therefore a reading of the roof and the attic rather than a fix at the stain.
Replacements follow a reading too. The layers, the deck and the number of counted details decide the scope, and a crew that has measured the roof can say what the job includes. Storm inspections are shorter visits that follow the same reading, with the findings written down for the record.
The failed section is found, traced and rebuilt, so the rest of the covering can stay on for years.
The old covering comes off to the deck, the deck is checked, and the new roof is built on sound wood.
The roof is taken off and rebuilt with the building still in use, which changes the order of every step.
Water on a flat roof sits and finds the weakest seam, so the repair starts with drainage and every joint.
Wind works at the edges first, so the repair starts with the rake, the ridge and the eave, then moves inward.
A post-storm inspection checks what the wind and water did, records it, and says what can wait and what cannot.
A secured tarp keeps rain off an open roof for the time it takes to schedule the real repair.
The leak is traced to its entry point, the flashing that failed is rebuilt, and the joint is tested before the crew leaves.
The metal that seals the chimney to the roof is rebuilt, and the mortar it sits in is checked where it has opened.
Asphalt shingle is the common covering on the city's houses, and a sound replacement starts with the deck it sits on.
Shake and slate are repaired piece by piece, so the work protects the sound material rather than replacing it.
Metal sheds wind and snow well, and its life near the bay depends on the fasteners, the finish and the edge detail.
Ice at the eave backs water under the shingles, so the job is to clear the blockage safely and find the leak it caused.
Air moving through the attic keeps the roof boards dry and cold, and it protects the shingles and the snow line.
A gutter that fails sends water onto the fascia, the wall and sometimes the neighbor's lot, so the repair follows the water.
The skylight is a joint in the roof, and its leak is usually at the flashing around it rather than in the glass.
A written report records the roof's condition with photographs, so the owner, a buyer or a landlord can act on the facts.
A seasonal check after each bay storm catches small wind damage before it becomes a leak.
| Service | Typical range | Details |
|---|
Estimates only. Your price is confirmed on site before work starts. See the full price guide.
Call any hour and explain what is going on. You get a clear price before any work starts.
Describe the symptom and the house, and the call will point to the right kind of visit. A leak, a loose edge and a planned replacement are handled differently, and the first visit confirms which applies.
Usually it is, because the materials, the drains and the way water moves across a flat or low-slope deck differ from a steep covering. The scope names each section separately.
The company that attends the building can say what it covers. Rental buildings raise access, notice and registration questions, and those are answered before the visit is booked.
Yes. The inspection is most useful once the wind has dropped and the attic can be entered safely. Call as soon as that is possible, and describe what you saw during the storm.