Fastest: call (833) 751-2102. Or send this and we call you back.
Skylight Replacement
Skylight Replacement: what it covers
Quick answer
Skylight replacement means removing an old unit, rebuilding the curb and flashing around the opening, and setting a new fixed or venting skylight with its own flashing kit. New Bedford Roofing replaces skylights across New Bedford and the nearby towns, and calls at (833) 751-2102 start with a look at the leak.
A skylight leaks more often at its frame than through its glass. The glazing seals in a factory-made unit, and the water that finds its way into the room runs down the curb or along the flashing that surrounds the opening. On an older roof the flashing was often set into the shingles years ago, and the sealant around it has long since shrunk or cracked.
The decision is whether the unit can be repaired or should be replaced. A failed seal in the glass, a cracked frame or a faded or clouded dome points toward replacement. A sound unit with a leaking flashing can sometimes be kept, but the flashing itself must be rebuilt to current standards, and the crew checks that the unit is still in good condition before it recommends keeping it.
Skylights on the South Coast also take the same wind and salt air as the rest of the roof, and their fasteners and seals age accordingly. A replacement is an opportunity to set the unit with a flashing kit that fits the roof covering, and to choose a type that suits the room below, whether it is fixed for light alone or venting for air.
A skylight opening is a hole in the roof, and an open curb or a temporary cover is a fall hazard. Crews secure the opening and work with fall protection. Homeowners should not stand on or near a skylight, which may not bear weight, and should keep children and pets away from the area below the work.
A stain on the ceiling around the skylight that grows after rain
Water staining on the frame or the wall beneath the unit
Condensation or fogging between the panes of the glazing
Cracked or yellowed dome or sealant around the frame
A flashing edge that has lifted or shows a gap at the curb
A venting mechanism that no longer opens or closes firmly
Daylight around the unit when the attic light is switched off
Our process
How our skylight replacement visit works
Assess the unit and the leak
The crew inspects the glazing, the frame and the mechanism from inside and outside. The leak is traced to the flashing, the curb or the glass, since each calls for a different repair. The condition of the unit decides whether it is kept or replaced.
Remove the old unit and flashing
The old skylight is removed carefully, with the shingles around it lifted and the flashing taken out. The curb and the rafters beneath are inspected for rot and for any water damage, and the opening is checked for square and level before the new unit is set.
Repair the curb and decking
Any soft or damaged sheathing around the opening is cut out and renewed, and the curb is rebuilt or repaired to take the new unit. The framing is checked for any notch or weak point that the opening has created, and the scope records it.
Set the new unit with its flashing kit
The new skylight is set into the curb and fixed with its flashing kit, which is fitted into the shingle courses above and below. The kit is installed in the order its instructions require, with each piece overlapping the one beneath so water runs out and over the unit.
Water-test and clean up
The completed joint is tested with water from the bottom up while someone checks the room below. Shingles are returned to their courses, the site is cleaned, and the homeowner is shown how the unit operates and how to check the seal.
Is a skylight leak in the glass or in the flashing?
Most skylight leaks come from the flashing or the curb around the unit, not from the glazing itself, and the leak is traced to the joint before any decision is made.
Water runs down the face of the glass and gathers at the frame, then follows the curb to the room below. The crew checks the flashing edge, the sealant and the curb for the path, since a failed seal in the glass shows as fogging between the panes rather than as a drip. Knowing which it is decides whether the unit can be kept.
Should an old skylight be repaired or replaced?
A sound frame and glazing with a bad flashing may be kept, while a cracked frame, a clouded dome or failed glazing is a reason to replace the unit.
The crew weighs the age of the unit, the condition of the frame and the effort of a flashing rebuild against a new unit with its own kit. A new unit is usually the cleaner answer where the old one has lost its seal or its operating mechanism, and the scope sets out the reasons so the homeowner can compare the options.
Why do the flashing kits matter so much?
A flashing kit is the set of metal pieces that ties the unit into the shingle courses, and a kit that does not match the roof covering will leak at its edges.
The kit must be sized for the unit and the pitch of the roof, and its upper pieces must lap over the shingles while its lower pieces lap under them. Installing it in the wrong order is a common cause of leaks, so the crew follows the manufacturer's sequence and records it in the scope.
Does a skylight replacement need a permit?
It depends on the town and on whether the opening is enlarged or the framing changed, so the building department should be asked before the job.
Setting a new unit in an existing opening is usually a smaller job than cutting a new one, but sources do not give one rule for the South Coast, and this site does not state a requirement. Where the framing is changed, the building department should confirm the requirement before the work is started.
Options
Types and options for skylight replacement
Fixed skylight
A fixed unit admits light and does not open. It is the simplest type to seal, since its frame has no moving parts, and it is often chosen for stair and hall spaces where air is not needed. The scope names the glazing and the frame material and states the flashing kit used.
Venting skylight
A venting unit opens to let warm air out of the room below, usually through a handle or a remote control. Its moving parts must seal when closed, so the flashing and the frame are checked for that as well as for light. The scope states how the unit is operated and how it is maintained.
Tubular skylight
A tubular unit carries light down a short shaft to a room with no roof opening of its own. It is a smaller job than a full skylight and suits a bathroom or a closet. The shaft and its flashing are checked, and the scope states the length of the tube.
Curb and flashing rebuild
Where the curb is rotted or the flashing has failed, it is rebuilt before the new unit is set. The curb is a built-up frame around the opening, and its joints are the most important part of the seal. A new unit on an unsound curb will leak within a season.
Glazing and dome replacement
Where the unit is sound but the glazing has failed, the glass or the dome is replaced in the existing frame. This is a smaller job than a full replacement, but it is only appropriate when the frame and the flashing are in good condition, which the crew confirms first.
Bristol County
Why skylight replacement is different in the South Coast
Many older houses in New Bedford have skylights that were added in a later decade, often over a stair or a bathroom at the top of the building. Their flashing was set into a roof that has since been re-covered, so the joint is usually the first thing to check.
On the South Coast the salt air and the strong winds of the bay take a toll on the seals and the mechanisms of venting skylights. The crew checks the operating hardware on each unit as part of the replacement, and it recommends a cleaning schedule for the glazing.
Skylights on the top floor of a multi-unit building affect the unit below as well as the roof. The work is planned with the occupants so that the room is protected, and the ceiling and fixtures beneath are covered while the opening is open.
Skip the guesswork. Call for a straight answer.
Tell us what's happening and we'll tell you honestly whether it's a quick fix, and what skylight replacement should cost.
Wind works at the edges first, so the repair starts with the rake, the ridge and the eave, then moves inward.
See details
FAQ
Skylight Replacement FAQs
Why does my skylight leak only in a storm?
Wind-driven rain pushes water under the flashing edge and into the gap around the curb, which a calm rain does not do. The leak is usually at the upslope flashing, where the water is driven hardest, and the crew traces it there first.
Can a fogged skylight be cleared?
Usually not. Fogging between the panes means the seal has failed, and the glazing has to be replaced or the whole unit set anew. Cleaning the outside will not clear it, and the crew can confirm the condition from the inside.
Is a venting skylight better than a fixed one?
Neither is better in general. A venting unit lets warm air out of the room, while a fixed unit has fewer moving parts to fail, so the choice depends on the room and on how the homeowner will use it. The scope names the type.
Will a new skylight change the roof's look?
It can, since the unit sits proud of the covering and its frame shows. The crew can set the unit flush with the shingle courses and match the flashing to the roof color, and the scope states the finish chosen.
Do you replace the shingles around the unit?
The shingles around the opening are lifted and returned to their courses, and any that are cracked are replaced. Where the covering around the opening is failing widely, the scope recommends a larger roof repair so the new unit is not set into weak material.
How do I arrange a visit?
Call (833) 751-2102 and say where the leak appears inside, whether it shows only in rain and whether the unit opens. The crew can usually tell from that what needs to be done before it goes onto the roof.